Mr Lawrence O'Connell from NSW at the factory using our Builder Assistance Program.
See his progress in this week by week presentation of pictures.
Page 3
Wait for all thumbnails to load, then click to enlarge.
| Week 6 | |||
|
Another good week and we only worked four days.
|
Here is a simple tool to line up the clutch pulley.
|
Mark and cut the clutch pivot. |
|
 |
 |
 |
|
|
Unit installed looks great.
|
|||
|
|
 |
 |
 |
|
|
Pedals
and spacers installed for the final time.
|
||
|
We are trying a mod
at the front shaft hole to stop the oil from leaking when it's
trailering. |
Blue exhaust should go well with the rest of the airframe. |
Oil Bath ready to install. |
All the heat shields cut and ready for bending. |
|
Week
7
|
|||
|
Week
seven was a good week and we only worked four days but we did
make a lot of progress. Here are the results:
|
Exhaust installed. |
 |
 |
 |
The main sprocket installed and lock wired. The bottom bearings installed and the top bearing is locked up at this stage. |
 |
The chain link cover with Tinnamen washers and counter sunk screws. |
|
The chain link is painted to make it easy to see when the oil bath is closed up. |
 |
 |
Oil bath finished and use lots of sealant as all the work can be carried out through the inspection window. |
 |
 |
 |
Collective installed. |
 |
Cooling system and radiator in place for the final time |
 |
 |
|
|
|||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|||||